Protect the corner edge from wear and damage, making the Yin Angle and Yang Angle 90 degrees more obvious, the edge line is smoother, fully protect the Yin and Yang Angle, improve its strength. Widely used in arch, arc, corner protection.

Product performance:

1, the metal corner belt is composed of the center of the two strips of 11mm wide imported high-quality hot-dip galvanized steel belt, after special processing and paper tape firmly bonded together, not only long-term rust prevention, but also to protect the Yang Angle, so that the Yang Angle straight and strong.

2, suitable for any Angle of the joint, especially for the ceiling shade corner to prevent cracking, so that the shade Angle straight.

3, the width of the metal corner belt is 50mm, the length of each box is 30m, compared with the traditional corner bar, the amount of putty is less, the length can be cut as needed, no joint, and the loss is small.

4, roll shape, easy to carry; Easy to cut, reduce waste; Suitable for a variety of shapes corner; Simple operation and convenient construction.

Product Specifications:

Size: 50mm×30m

Color: White

Packing: 10 rolls/box

Product substrate:

Paper tape adhesive galvanized steel or aluminum metal strip

How to use:

1. According to the actual measurement length of each side on the site, the metal corner guard belt is cut vertically with scissors to meet the construction length requirements.

2. Apply seam putty on both sides of the corner, fold it according to the center line of the metal corner guard belt, paste the metal steel strip surface in the seam putty (the metal steel strip side should be pasted inside), squeeze out the excess putty, and clean the surface with a trowel knife. During construction, the metal corner guard belt can not be overlapped, otherwise it will affect the flatness.

3. After drying, use a layer of joint putty on the surface. If necessary, use fine sandpaper to gently polish.